HydroPro Floor Paint
HYDROPROFLOOR
An innovative high performance single pack cross linking water based floor paint for domestic and light industrial use. Suitable for internal and exterior application to suitably prepared bare and previously painted floor areas including bedrooms, kitchens, domestic garage, workshop, office, and studio, once cured resistant to oils, grease and light industrial traffic. Water based, low odour and quick drying with low VOCs Tough, hard wearing mid sheen finish Formulation offers superior adhesion and durability, suitable for internal and external application Resistant to oils and grease and easy to maintain Touch dry 30 – 45 mins Recoat after 1 hour @ 20°C Soap and water clean up
Data Sheets
Technical Properties
Coverage
12sq m /lt at 25 microns dft
Storage
Store between 5°C - 25°C. When not in use, cans must be kept sealed
Shelf Life
12 months from delivery date in original sealed containers
Maximum VOC Content
0.010 Kg/l
Regulations
2004/42 IIA WB (I) 140
Colour Range
Available in Light Grey (RAL7038), Mid Grey (RAL7037), Dark Grey (RAL7015) Yellow (RAL 1018), Tile Red (L31707) and Mid Blue (RAL5015)
Cleaning
Please read HMG Knowledge Base Article - Preparation of Concrete Floors Prior to Coating - KNB0012 https://www.hmgpaint.com/knowledge/knowledge-base/63/preparation-of-concrete-floors-prior-to-coating Substrate to be clean, dry and free of oils, grease, dust and other contamination prior to application. High pressure clean to remove all loose debris and contamination. Degrease using suitable degreaser and scrubbing action to remove any contamination not removed from cleaning alone. Bare concrete: Power floated/non porous should be etched or abraded prior to painting, this can be achieved by etching using an acid etch or blasting either vacuum or similar, please see knowledge base above. Porous concrete should be checked for laitance, if this is present then prepare as above. Previous coatings: Check previous coatings are compatible with any new coating to be applied, all coatings should be sound and well adhered with all failed and damaged areas removed back to firm well feathered edge. Lightly abrade to provide key. Bare wooden floor: Lightly abrade, hard wood floors should be wiped using methylated spirit to remove any resin from the surface, primed to avoid resin bleed using aluminium primer. Soft woods may require knotting treatment prior to application of thinned first coat. Steel or metal: Prepared to remove all rust/corrosion and primed using suitable primer. For full surface preparation please refer to our web site for Knowledge Base article Prep Cleaning Techniques (KNB0009) and Preparatory Cleaners from the Product Guide. If in doubt speak to HMG Technical Department on 0161 205 7631.
Surface Preparation
Please refer to Knowledge Base on our website for details on Surface Preparation.
Health & Safety
- Refer to SDS and tin label prior to use.
Issued
02/08/2023 00:00:00